« previous next »
Pages: [1]

Author Topic: trans output flange slotted nut torque requirement  (Read 3493 times)

Joe

  • Full Member
  • Silver
  • ****
  • USA, CO, Colorado Springs
  • Posts: 383
trans output flange slotted nut torque requirement
« on: July 21, 2009, 21:51:30 »
Does anyone know this? I can't find mention of the actual torque value on our site, nor in the BB.
Joe
Logged

Jonny B

  • Pagoda SL Board
  • Platinum
  • ******
  • USA, CA, San Marcos
  • Posts: 4182
Re: trans output flange slotted nut torque requirement
« Reply #1 on: July 21, 2009, 22:42:13 »
Will need a confirmation on this one, as I am not sure these are what you are asking about

From the 1966 Technical data manual, (the verbiage used in the book)

Grooved nut for three-arm flange - auto 8 mkp
Grooved nut for mounting three-arm or joint flange - manual, 14-15 mkp

1 mkp = 7.233 ftlb
Logged
Jonny B
1967 250 SL Auto, DB 568
1970 280 SL Auto, DB 904
1966 Morris Mini Minor

Benz Dr.

  • Vendor
  • Platinum
  • ******
  • Canada, ON, Port Lambton
  • Posts: 7217
  • Benz Dr.
Re: trans output flange slotted nut torque requirement
« Reply #2 on: July 22, 2009, 03:52:30 »
That doesn't make any sense to me. Why would one be 8 mpk and the other one 14 or more?
Logged
1966 230SL 5 speed, LSD, header pipes, 300SE distributor, ported, polished and balanced, AKA  ''The Red Rocket ''
Dan Caron's SL Barn

1970  3.5 Coupe
1961  190SL
1985   300CD  Turbo Coupe
1981  300SD
2013  GMC  Sierra
1965  230SL
1967 250SL
1970 280SL
1988 560SEC

Joe

  • Full Member
  • Silver
  • ****
  • USA, CO, Colorado Springs
  • Posts: 383
Re: trans output flange slotted nut torque requirement
« Reply #3 on: July 22, 2009, 05:33:32 »
Thanks, Jonny, that's what I needed. That is a lot of torque to apply to a slotted nut.
Joe
Logged
Pages: [1]
« previous next »