Author Topic: dipstick pipe A127 010 08 66  (Read 3145 times)

114015

  • Full Member
  • Platinum
  • ******
  • Germany, Nordrhein-Westfalen, Tecklenburg
  • Posts: 2080
dipstick pipe A127 010 08 66
« on: November 04, 2011, 18:39:14 »

Hello,

Does anybody of you know how to pull off the engine's dipstick pipe from the (large) oil pan?
Mine is rusty and I would like to have it zink-plated.

It appears to me that it is only stuck in but not screwed in or so. It's tight, could it be that it is glued? :o
Or is it possible to just pull it out?

Many thanks in advance,

Achim
Achim
(Germany)

ja17

  • Full Member
  • Platinum
  • ******
  • USA, OH, Blacklick
  • Posts: 7414
Re: dipstick pipe A127 010 08 66
« Reply #1 on: November 05, 2011, 00:28:19 »
Hello Achim,

They are a tight fit, but are just forced into place. Most likely the factory used a little sealer around them. I always use heat on the aluminum around the pipe. Then twist back and forth while pulling upward.  It seems to help a lot.

Tough ones may require a slide hammer to remove. Fit a collar around it and hook the slide hammer to the collar and pop it out.
Joe Alexander
Blacklick, Ohio
1969 Dark Olive 280SL
2002 ML55 AMG (tow vehicle)
2002 SLK32 AMG (350 hp)
1982 300TD Wagon turbo 4spd.
1963 404 Mercedes Unimog (Swedish Army)
1989 flu419 Mercedes Unimog (US Army)
1998 E430
1974 450SLC Rally
1965 220SE Finback

114015

  • Full Member
  • Platinum
  • ******
  • Germany, Nordrhein-Westfalen, Tecklenburg
  • Posts: 2080
Re: dipstick pipe A127 010 08 66
« Reply #2 on: November 07, 2011, 20:40:20 »
Dear Joe,

Thanks a lot for your advice.
I will give it a try.

Best,

Achim
Achim
(Germany)