« previous next »
Pages: [1]

Author Topic: Center bearing  (Read 2260 times)

reg

  • Full Member
  • Junior Level
  • *
  • Canada, BC, Victoria
  • Posts: 28
Center bearing
« on: March 22, 2017, 23:22:34 »
I need help.   Have my drive shaft out but do not want to break this aluminum housing.  What do I need to do to get this off and put in the new bearing. This is a 1966 230sl auto.  Thanks in advance as I don't post very often
« Last Edit: March 23, 2017, 03:13:34 by reg »
Logged

Benz Dr.

  • Associate Member
  • Platinum
  • ******
  • Canada, ON, Port Lambton
  • Posts: 7220
  • Benz Dr.
Re: Center bearing
« Reply #1 on: March 23, 2017, 17:08:13 »
Did you mark everything before you took it apart? The drive shaft is balanced and should be assembled in the same way it came apart.

Isn't there a snap ring that holds the bearing in place?
Logged
1966 230SL 5 speed, LSD, header pipes, 300SE distributor, ported, polished and balanced, AKA  ''The Red Rocket ''
Dan Caron's SL Barn

1970  3.5 Coupe
1961  190SL
1985   300CD  Turbo Coupe
1981  300SD
2013  GMC  Sierra
1965  230SL
1967 250SL
1970 280SL
1988 560SEC

reg

  • Full Member
  • Junior Level
  • *
  • Canada, BC, Victoria
  • Posts: 28
Re: Center bearing
« Reply #2 on: March 23, 2017, 17:25:23 »
thanks for the info    just need a better puller   all should be fine   and I did mark everything so it should go smoothly..   have been chasing this noise for awhile
Logged
Pages: [1]
« previous next »