« previous next »
Pages: [1]

Author Topic: Rear Axel Bearing  (Read 2054 times)

CJHenderson

  • Full Member
  • Silver
  • ****
  • USA, AR, Benton
  • Posts: 469
Rear Axel Bearing
« on: September 20, 2018, 00:17:16 »
When seating the bearing and then the lock washer and axel nut I noticed a space between the bearing and lock washer approximately 1/4 inch. Is this normal?
 
Logged
1970 280SL/8 W113 101624 miles.
1950 MG-TD
2021 Harley Davidson CVO Trike

Benz Dr.

  • Associate Member
  • Platinum
  • ******
  • Canada, ON, Port Lambton
  • Posts: 7220
  • Benz Dr.
Re: Rear Axel Bearing
« Reply #1 on: September 20, 2018, 14:54:42 »
The lock plate has a shoulder on it that should face down during installation. This should provide a small gap between the bearing and the lock plate so that you will be able to pry the plate up and into the slots on the nut. This gap shouldn't be anywhere near 1/4 inch though.
Logged
1966 230SL 5 speed, LSD, header pipes, 300SE distributor, ported, polished and balanced, AKA  ''The Red Rocket ''
Dan Caron's SL Barn

1970  3.5 Coupe
1961  190SL
1985   300CD  Turbo Coupe
1981  300SD
2013  GMC  Sierra
1965  230SL
1967 250SL
1970 280SL
1988 560SEC

ja17

  • Full Member
  • Platinum
  • ******
  • USA, OH, Blacklick
  • Posts: 7414
Re: Rear Axel Bearing
« Reply #2 on: September 20, 2018, 16:02:29 »
Yes as Dan explains, too much gap. Sounds like the lock washer hung-up during installation.
Logged
Joe Alexander
Blacklick, Ohio
1969 Dark Olive 280SL
2002 ML55 AMG (tow vehicle)
2002 SLK32 AMG (350 hp)
1982 300TD Wagon turbo 4spd.
1963 404 Mercedes Unimog (Swedish Army)
1989 flu419 Mercedes Unimog (US Army)
1998 E430
1974 450SLC Rally
1965 220SE Finback
Pages: [1]
« previous next »