Some questions....

[antonio martinez]

Good morning.
1.- I am trying to put in my 230 sl 1965 a radio Becker Europe and I don't know how to disassemble the two buttons and cover to put it in its place ....
I have the two pieces with screw to place it, but first I must disassemble the front of the radio ....
some clue?
2.- what is the cable connection, in the heating box, passenger area? It looks behind the glove compartment ...
What it is for?...

Thanks for all
Regards

[Peter]

Hi Antonio,

The buttons are without screw. You can pull them of with appropriate force.

On the heater box left site is a connection, in my 280SL, for the glovebox light wiring.

Success, Peter

[ja17]

The early Becker radio knobs do have a tiny set screw in the side. The later Becker radio knobs just push on or pull off. The wire going to the glove box light is connected to a terminal block under the dash.

[scoot]

1.- I am trying to put in my 230 sl 1965 a radio Becker Europe and I don't know how to disassemble the two buttons and cover to put it in its place ....

First of all, what Becker are you trying to install?  It needs to be a small-face Becker.  (early).  See here for a pictures showing the difference between the two:  https://www.sl113.org/wiki/Electrical/Radio   Scroll down to the picture.   You need a small-face Europa TR or TG (or Grand Prix but that would be very rare).  Hopefully you have a small-face Europa TR.  Post a picture of the radio and amplifier you are trying to install.  Assuming you have an early small face radio, the knobs are held in by set screws.