W11x 1968 coupe Rear End Camber after rebuild

[stewarttt]

   I have just installed the rear end back in a 1968 w111 coupe that I am restoring. ( see pics below ).
  The camber is way off and I assume that is because there is no weight in the car at the moment.
  Since the left side axle and differential housing are at a slight downward angle and not level, the tubular carrier rubber mount is being twisted at a slight angle and I was concerned about the this rubber carrier mount being damaged. Am I worried about nothing, and will the axle and camber level out once I put the engine and trans back in the vehicle?

[ja17]

Some weight and a bit of driving should help. Thinner rubber pads under the cross spring may help also. You might also adjust the spring bases to a lower setting. I would wait until it is loaded and driven-in before trying to adjust anything. Nice work, the car looks great!

[stewarttt]

  Thank you, Just about all of my knowledge about restoring one of these cars has come from this website which I have been reading and using for the past seven years. Again, very much appreciated.