Author Topic: Emergency brake boot  (Read 2021 times)

jpsenft

  • Full Member
  • Junior Level
  • *
  • USA, MD, Silver Spring
  • Posts: 26
Emergency brake boot
« on: August 15, 2007, 16:42:44 »
Have just received a new emergency brake boot.  Any suggestions on how to slide it to its final position?  It is so "grabby" it stops sliding right at the top of the handle.  Force it down?  Lubricate the brake handle?  Roll in down?  At $30 for the part, I don't want it to split! Suggestions welcome!

1965 230SL
Silver Spring, Maryland
1965 230SL
Silver Spring, Maryland

mdsalemi

  • Pagoda SL Board
  • Platinum
  • ******
  • USA, NC, Davidson
  • Posts: 7059
Re: Emergency brake boot
« Reply #1 on: August 15, 2007, 16:49:47 »
JP,

Try this stuff called "slime".  No kidding.  It goes by a variety of names but it is used by electricians to pull cables through rigid conduit.  You can get it at Home Depot or Lowe's in the electrical department.  Does not harm anything, and the excess will easily be wiped off.

One manufacturer to look for is GB, and their version is called "Wire Aid".  Good Luck!

Michael Salemi
1969 280SL
Signal Red 568G w/Black Leather (Restored)
President, International Stars Section
Mercedes-Benz Club of America
Michael Salemi
Davidson, North Carolina (Charlotte Area) USA
1969 280SL (USA-Spec)
Signal Red 568G w/Black Leather (Restored)
2023 Ford Maverick Lariat Hybrid "Area 51"
2023 Ford Escape Hybrid
2024 Ford Mustang Mach Ex PEV