First
First, I'd like to thank the group and the administrators for this most valuable source of information. I have used it countless times to research questions and always seem to find the answer. I've just begun to do the linkage tour and have a couple of questions for anyone who might know.
1) Attached is a picture of the IP linkage rod. One nut is welded to the rod. It looks like a PO decided to do some welding or is this correct (or maybe threadlock on steroids)? If not, does anyone know where to get another. I plan to replace ball sockets and bushings as well if one supplier can provide all.
2) A clamp was used to keep the crossover rod from slipping out of the bushing and just from looking it over, I'm guessing a circlip goes on the end of the rod. Is this correct and does anyone have a part # or access to that.
Thanks again to all,
Jim