Right,
Got all the necessary O rings, removed pump and followed the tech manual to the letter.
Managed to remove all the screws from the underside of the pump.
Removed bellows, no leaks or holes.
Replaced O ring under bellows
Replaced locating washer, circlip, impeller etc etc.
Replaced main O ring and installed new bolts to bottom of pump.
Reconnected and Ran the pump.... fuel pouring from the overflow worse than before!!!
The small O ring I installed looked a smaller cross section than the original I removed. I ordered the correct part and size as per tech manual.
I made sure the bellows were fully seated on the O ring before installing circlip.
So what have I done incorrectly or is the pump unserviceable??
George???
Naj???
Anyone else??