Author Topic: Hardtop Fitting  (Read 2841 times)

RBYCC

  • Guest
Hardtop Fitting
« on: August 31, 2012, 10:43:57 »
Put the hardtop on my car yesterday for the first time....needed to make some room so I could tidy up my garage !!

The hardtop is not original to the car but assume all tops should be interchangeable.

Top latches down tight in the front and rear sides but there is a gap at the rear where the top meets the body.
The gap is about a half inch at the chrome molding but the seals seem to fit against the cover..

Is there any adjustment to snug the rear of the top to the body ?

Thanks

Ed A.

Ulf

  • Associate Member
  • Gold
  • *****
  • Denmark, Fredericksberg, Rungsted Kyst
  • Posts: 838
Re: Hardtop Fitting
« Reply #1 on: August 31, 2012, 10:53:30 »
Have you tried lashing the rear lashes first, then the front ones? Might not help, but it's really easy to try :-)
1965 230 SL in silver (DB180)
1982 Land Rover Series III SWB
2008 Jaguar XF 3.0
2005 Mini Cooper

Garry

  • Full Member
  • Platinum
  • ******
  • Australia, Victoria, Kyneton and Brisbane Queensland
  • Posts: 5236
  • Audit Committee
Re: Hardtop Fitting
« Reply #2 on: August 31, 2012, 11:25:22 »
Looking from the rear the top correctly fitted appears to be half an inch or more off the deck but the seals are on the lid ok. The  That is it looks like you could get your fingers under the rear of the hardtop.  Is that what you have and is so then that is the norm.  Attached is a photo of mine, original top on car.
Garry Marks
Melbourne/ Kyneton, Brisbane. Australia
1969 MB 280SL 5 speed RHD SOLD.
1965 MB 230SL Auto RHD Lt Blue 334G, Top 350H, Tourist Delivery.
1972 MB 280CE Auto RHD 906G
2005 MB A200
2006 MB B200
2019 Izuzu DMax 4x4 Slide-on camper.
2022 Volvo XC40 Electric
2024 Volvo EX30 Electric

RBYCC

  • Guest
Re: Hardtop Fitting
« Reply #3 on: August 31, 2012, 12:40:03 »
Thanks Gary !!!

That's similar to my fit..
Seals are down on the lid, but there is a "finger" gap where the top meets the body sheetmetal...

So not to worry about the design !!!

Thanks again..
Ed A.