Accelerator pedel mount welded to floor or free floatin?

[Green68MB]

Is the accelerator pedal mount welded to the floor panel or is it just attached to the rubber pedal?  When I pulled up my carpeting , I found rust at the exact area and wondered if it broke loose or was never attached.  Any info is appreciated. Thanks

[dirkbalter]

Its welded to the floor.

[Green68MB]

Thanks, After I pulled the carpet up the mount was loose and still attached to the rubber  pedal.   

[dirkbalter]

If your floor panels are still strong enough, you can weld it back in. I took some dimensions before I removed my bracket and can post them if needed.
(Not sure if I would go that route but if welding is not an option, you could probably drill holes and screw the bracket to the floor.) 

[Green68MB]

Thanks, the screw  solution seems  most probable

[swood1]

Hi Dirk,

Would you mind posting your dimensions please?  I am just going through process of replacing my floor panels.  The original bracket was missing.

Regards

Steven

[dirkbalter]

Steven,
The dimensions I wrote down before I cut the floors out:
3 3/4" (85.7mm) from the tunnel wall to the outer edge. See pic
2 1/4" (57.1mm) from the transition of the floor panels  to the front edge of the bracket. See pic

Hope that helps
   

[swood1]

Hi Dirk,

Thanks very much for this information. 



Kind Regards

Steven